Acousto-optic tunable filter with RF driver is all solid-state spectroscopic device, which is mainly used at the wave range of visible light. It has no moving parts. It adopts electronic signal to control scanning and has quick wavelength switching to meet the need of real-time rapid detection. It is provided with the auxiliary driver, and the devices with different wavelength range and resolution parameters can be customized according to user requirements. High precision,
high resolution, quick scanning speed and broad scanning range.
The device is driven by typical signal generator or TTL.
Most of the specifications can be customized according to your requirements.
Acousto-optic Tunable Filters AOTF is an acousto-optic devices which can be used for filtering light, controlled with an RF input.
An acousto-optic tunable filter (AOTF) is a kind of optical filter which is based on a kind of acousto-optic modulator. Wavelength tuning is electrically controlled through the applied RF frequencies.
The basic operation principle is explained in the following. If a sinusoidal (fixed-frequency) RF input signal is applied to the modulator, diffraction is possible only in a narrow range of optical frequencies, where a phase matching condition involving both optical and acoustic waves is fulfilled. Looking at the diffracted light, one obtains a bandpass filter, while the non-diffracted light provides a notch filter.
With RF waves of different frequencies, one can address different regions of optical frequencies. One may, for example, use an optical input from an argon ion laser emitting on different laser lines, and with the tunable filter one can transmit just one of those lines at a time.
It is also possible to use any superposition of different RF frequencies in order to obtain diffraction for different optical frequencies. The diffraction efficiency at any wavelength can be controlled via the corresponding RF power.
Depending on the design, a AOTF may work over an optical wavelength range which is hundreds of nanometers wide. Other devices are optimized for high resolution in a narrower wavelength range. Some of them also work with ultrashort pulses.
Acousto-optic Filter Designs
Because the requirements for different applications are quite diverse, different types of acousto-optic filters have been developed.
Some devices use a collinear interaction between light and sound waves. For example, one may use a tellurium oxide (TeO2) crystal, having a high acousto-optic figure of merit, and apply acoustic shear waves (i.e., with the oscillation perpendicular to the beam direction). The diffracted light will then have a polarization direction which is perpendicular to that of the linearly polarized input light. It is thus easy to isolate the diffracted light after the device with a polarizer. Such devices have a small acceptance angle, i.e., they work only with an appropriately aligned laser beam having a limited amount of beam divergence.
There are also tunable filters based on a non-collinear geometry. These typically have a much larger acceptance angle, but only a quite limited interaction length, so that the diffraction efficiency is correspondingly reduced, or higher RF powers are required.
Some devices can work with an unpolarized input, exploiting the birefringence of the used crystal material.
Different filter designs can differ greatly in terms of various performance parameters, for example
the addressable range of optical wavelengths,
the spectral resolution and quality of sidelobe suppression, and
the diffraction efficiency and required RF power.
The requirements of the used RF driver also depend very much on the device design and its application.
Applications of Acousto-optic Tunable Filters:
A widespread application of AOTF is in multispectral imaging, e.g. in the form of laser microscopy. The
